Vacuum casting vs injection moulding
Somewhere between five prototypes and five thousand parts there is a gap. A 3D printer is too slow and costly, and a steel mould is too much commitment. Vacuum casting fills it.
First a master pattern is printed, usually in SLA. A silicone mould is poured around it. Then polyurethane resin is cast into the mould under vacuum, which draws out bubbles and picks up fine detail. The parts look and feel close to moulded ones, in ABS-like, clear or rubber-like grades.
The catch
Silicone wears out, so one mould makes a limited number of parts, typically in the tens. Expect tolerances of about ±0.3 % with a floor around ±0.2 mm, and a material that is close to production plastic but not identical.
When to move to a hard tool
Once you need hundreds or thousands, the cost per part from an injection mould falls well below casting, and you get true production plastics. Where exactly that crossover sits depends on the part. Design for both from the start: 1–2° of draft, even walls, generous radii. The same model then moves from casting to tooling without a redesign.