SLA or DLP: how to pick a resin printer
Both cure liquid resin with light, and both give smooth, detailed parts. The difference is how the light reaches the resin.
An SLA printer draws each layer with a laser, like a pen. A DLP printer projects the whole layer at once, like a slide projector. So DLP is quicker when the plate is full of small parts, because every part is exposed in the same moment.
Where the detail comes from
A DLP image is a grid of pixels, so detail depends on pixel size. Spread the same image over a bigger plate and the pixels get bigger. A laser spot stays the same size wherever it points, which is why SLA holds its detail on larger parts.
What happens afterwards
It is the same for both: wash, remove the supports, post-cure under UV. Resin parts can be brittle, so do not assume one will survive a load that a nylon part would.
Which one to reach for
Small, detailed batches such as jewellery patterns suit DLP. Bigger master patterns and fit-check models suit SLA. If the print is going to become a silicone mould for vacuum casting, surface finish matters more than speed, and either will do.