ASA, ABS or PETG for functional parts

These three sit side by side on the filament shelf and cost about the same, which makes them easy to swap by mistake. They behave differently once the part leaves the printer.

ASA is the one for outdoors. It holds up against UV, so it does not yellow and crack in the sun the way ABS does. Use it for housings and exterior vehicle parts. Heat resistance is similar to ABS, roughly 90–100 °C.

ABS is tough and handles heat, which suits indoor enclosures and functional parts. It prints best in an enclosed machine, and it breaks down slowly in strong sunlight.

PETG prints easily with little warping, even on an open printer, and it resists moisture and many chemicals. The limit is heat: around 70–80 °C, so keep it away from engines and hot surfaces.

Start with where the part will live. In the sun: ASA. Indoors and warm: ABS. Wet or chemical exposure at moderate temperature: PETG. Then print a small test piece and load it before committing to a batch.